MuskieFIRST | GPS receiver gasket? for installation » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> GPS receiver gasket? for installation

Message Subject: GPS receiver gasket? for installation

muskyslayer96

Posted 5/4/2013 6:51 AM (#639137)
Subject: GPS receiver gasket? for installation

Posts: 615

Location: Madison, WI

Hey fellas.......please help. I got the nerve to drill a 5/16 hole on my glass boat at the train some above the transducer to install my GPS receiver (puck). The wire will run directly below the receiver, but there is no gasket between the glass and the receiver to prevent water from getting in (through the side wire notches and into the 5/16 hole I drilled.
What to do? Am I missing something or can I buy a gasket to fit my purpose? Has anyone made one?
Any advice would be much appreciated
Best
MS

markb11

Posted 5/4/2013 7:18 AM (#639139 - in reply to #639137)
Subject: RE: GPS receiver gasket? for installation

Posts: 138

use marine silicone as the gasket as you describe....same as you use for your transducers

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread