MuskieFIRST | Outboard mounting sealant question » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Outboard mounting sealant question

Message Subject: Outboard mounting sealant question

Slimeball

Posted 3/29/2013 11:02 AM (#630586)
Subject: Outboard mounting sealant question

Posts: 332

Location: Michigan

My new Alumacraft has arrived at the dealer. I went in last week to check it out and bring my electronics to have rigged.
They had put the F90 on the transom and I noticed a thick white caulk/sealant all the way around the mounting bracket. It was not even a smooth bead (1/2 inch wide) and looked terrible.
Is this normal? I thought sealant was just used on the bolt/bolt holes?
thank's,
Jay

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread