MuskieFIRST | TAILS AND SCREWS » Basement Baits and Custom Lure Painting

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Random quote: what would libby do?
- (Added by: kap)

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] More Muskie Fishing -> Basement Baits and Custom Lure Painting -> TAILS AND SCREWS

Message Subject: TAILS AND SCREWS

Turkeyt

Posted 12/28/2012 8:07 PM (#605816)
Subject: TAILS AND SCREWS

Posts: 260

Location: Almost Heaven

Where is a good place to get the replacement squirrely tails and the cork screws to fasten them to for hard baits? Thanks guys

Guest

Posted 12/31/2012 2:43 PM (#606377 - in reply to #605816)
Subject: RE: TAILS AND SCREWS

You can easily make the 'cork screws' yourself out of single strand stainless leader wire or welding wire - just need a pair of round nose pliers and a bit of practice. Cut the leading end at an angle to get a point that'll twist in easily.
For the other end that fits into the bait just do a tiny loop (and squash it a bit if necessary) and epoxy it in.

Regards,
Mark

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread