Muskie Discussion Forums
| Moderators: Slamr | View previous thread :: View next thread |
| Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> rod balancers |
mseybert |
| ||
Posts: 443 Location: Indiana | I wanted to try balancing my rods, but found that the ones from BPS did not fit over my fat cork grips. Then I wanted to balance the rods without altering how they were built. I did it two different ways and both worked well. I had an epiphany. I have a lot of lead sinkers and solder lying around, could I use that? Yes! For a shorter rod that needed less weight, I put some large heat shrink tubing over the rear few inches of cork. Then I wrapped solder around the rod until balanced. Put another piece of heat shrink over it and done. For a longer rod that needed a lot of weight, I tried the same thing, but it looked bad. So I got out the drill bits and drilled a hole in a 4X4 the diameter of the cork. Melted the amount of lead needed to balance the rod and poured it into the hole. Let it set up, put a dab of hot glue on the lead slug and stuck it to the but of the rod. Heat shrink tube over that and done. I think they look pretty darn good. Attachments ----------------  IMG_1869.JPG (52KB - 204 downloads) IMG_1870.JPG (22KB - 177 downloads) | ||
| muskiewhored |
| ||
Location: Oswego, IL | |||
| mseybert |
| ||
Posts: 443 Location: Indiana | |||
| Tim Schmitz |
| ||
| Basschamp167 |
| ||
| archerynut36 |
| ||
Posts: 1887 Location: syracuse indiana | |||
| mseybert |
| ||
Posts: 443 Location: Indiana | |||
| Jump to page : 1 Now viewing page 1 [30 messages per page] |
| Search this forum Printer friendly version E-mail a link to this thread |
