MuskieFIRST | Water pressure guage feed line repair » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Water pressure guage feed line repair

Message Subject: Water pressure guage feed line repair

Marshall

Posted 2/2/2009 1:32 PM (#358696)
Subject: Water pressure guage feed line repair

Posts: 406

Location: Stones throw away...finally!!

I noticed a cut in my water line that goes to my water pressure guage the other day and was wondering gif you can splice a piece in, or patch that tube. It is similar to the line that you would put to your fridge for the ice maker. The placement of the cut is about 2-3 inches from the block. I suppose I could run the entire length again, but not too excited about fishing it through the fiberglass. Any help would be great.

VMS

Posted 2/2/2009 2:00 PM (#358703 - in reply to #358696)
Subject: Re: Water pressure guage feed line repair

Posts: 3480

Location: Elk River, Minnesota

Hiya,

I would bet you could go to the local hardware store and get an end to end joint with both ends being hose barbs. If anything, you could run a new line from the block to just outside of the engine, then use the double barbed joint with a couple of plastic tie straps to secure it.

That would be about it. So long as the seal is tight (which with the barbed ends and bar-ties, shouldn't be any issue)

Quick and easy fix...

Steve

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread