|
|
Posts: 496
| How long do you guys recommend spinning baits that have been coated with Envirotex ? Also how long do you let dry between coats. Do you spin them the entire time ? Thanks for the help
Dinver
|
|
| |
|
Posts: 2378
| I have my wheel on a timer that I set for 8 hours. Not sure you need it that long, but I get good results at 8 hours and I'm not interested in experimenting to find the minimum time needed |
|
| |
|
Location: Des Moines IA | In my limited experience it all depends on the ambient room temperature. The warmer the room, the less time it takes to dry. I've had it solid as a rock in as little as 6 hours, but that was during a 90+ degree day with them spinning in a closed garage. I've also had them take as long as a couple days to completely set up in a 55 degree basement in the middle of winter? So it's all relative. |
|
| |
|
Posts: 82
Location: Central WI | I usually run them around 8 hours as well at 3-4 rpm. Sometimes I'll start them right before bed and when I get up, there ready for the next coat. MuskieMike is right about the temperature too. If I do baits in the basement, it takes almost a whole day longer to get them to harden up.
Have Fun!!!
Edited by Legacy Lures 1/28/2009 2:14 PM
|
|
| |
