MuskieFIRST | Fogging a 225 vmax » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Fogging a 225 vmax

Message Subject: Fogging a 225 vmax

Marshall

Posted 11/27/2008 8:30 AM (#347100)
Subject: Fogging a 225 vmax

Posts: 406

Location: Stones throw away...finally!!

I have a 225 2 stroke vmax and just fogged the carbs and was wondering if I needed to remove the plugs and fog into the cylinders or if the carb shot was enough? I fogged it pretty heavy through the carbs. It is pretty easy to do the plugs too, just wasnt sure it was necessary. Thanks.

archerynut36

Posted 11/27/2008 9:30 AM (#347105 - in reply to #347100)
Subject: Re: Fogging a 225 vmax

Posts: 1887

Location: syracuse indiana

i dont know about the vmax.. it has carbs? i do know that carbs you can fog them but efi or dfi engins you cannot for them at all.. if you do then you have done something that will cost you.. i know that optimax's you just need to put 1 oz of opti iol in each cylinder and turn her over and run sea foam throu her or the merc stuff.. but not sure about the vmax.. i know there are other sites on just marine engins that can tell you all about your motor...bill

archerynut36

Posted 11/27/2008 9:44 AM (#347106 - in reply to #347100)
Subject: Re: Fogging a 225 vmax

Posts: 1887

Location: syracuse indiana

Edited by archerynut36 11/27/2008 10:03 AM

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread