Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Moderators: Slamr

View previous thread :: View next thread
Jump to page : 1
Now viewing page 1 [30 messages per page]

Muskie Fishing -> Muskie Boats and Motors -> reconfiguring Lund boat
 
Reply New post
Message Subject: reconfiguring Lund boat
djwilliams
Posted 2/23/2008 10:32 PM (#303425)
Subject: reconfiguring Lund boat




Posts: 767


Location: Ames, Iowa
How hard is it to take a bench seat out of a Lund boat? Does this involve aluminum welding to repair rivet holes? I am thinking of removing one or two of the benches to open up the middle and maybe put in a rod locker too. I made a nice floor for my boat with casting deck, so I don't have problems doing woodwork, bracing, carpet. What ideas do you guys have. I see there's a place in near Stillwater, Mn that does this work too.

Thanks,
djwilliams
sorenson
Posted 2/24/2008 8:50 AM (#303457 - in reply to #303425)
Subject: RE: reconfiguring Lund boat





Posts: 1764


Location: Ogden, Ut
Just remain cognizant of the probability that much of the boat's flotation is in the seat benches/supports. You'll have to find a spot to replace an equal amount of flotation in the new configuration. Some of the structural integrity of the hull is also maintained by the existence of the seats. I'd talk to someone who knows a whole lot more about it than I do before proceeding.
S.
floydss
Posted 2/25/2008 9:20 PM (#303841 - in reply to #303425)
Subject: Re: reconfiguring Lund boat





Posts: 282


Location: north west wisconsin
i have a 14' alumacraft that i took all three benchs out and built a casting deck up front and a deck in the rear have not had any problems other than a little shaking it all depends on the thickness of your alum. I can go in about 8 inches of water with about 650 pounds in the boat so it floats pretty well.
Jump to page : 1
Now viewing page 1 [30 messages per page]
Reply New post
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)