|
|
Posts: 16632
Location: The desert | It's been out of water for a day or so now and I can hear water sloshing around inside.....Not sure where the hole in it is, any ideas on fixing? |
|
|
|
Posts: 2427
Location: Ft. Wayne Indiana | Hang it up in the musky room and buy a new one. |
|
|
|
Posts: 691
Location: nationwide | Drill a 3/32" or 1/8" hole in it and let the water drain out .... . it may take awhile though .....unless you can roll up paper towel small enough to wick the stuff out, then fill the hole with silicone. I had a few of these and it seemed to work. I drilled the hole in the bottom right ahead of the joint.
Corey Meyer
Edited by muskymeyer 9/17/2007 4:38 PM
|
|
|
|
Posts: 2015
| Someone on another post mentioned -Drill hole fill with "great stuff"- to keep weight from coming loose - might be worth a try. |
|
|
|
Posts: 170
| My best topraider runs "very" low in the water...maybe not full of water, but it sure outperforms my others. |
|
|
|
Posts: 16632
Location: The desert | Cant afford to buy a new bait......looks like I'll start drilling. |
|
|
|
Posts: 2091
Location: Stevens Point, WI | I can donate a Topraider to a poor college kid. I'll give you one when we get out. |
|
|
|
Posts: 5874
| Ditto on the drill the hole and fill with Great Stuff. That will make the bait run better, and no more water can get in.
Edited by Shep 9/18/2007 8:02 AM
|
|
|
|
Posts: 2427
Location: Ft. Wayne Indiana | Just "borrow" one from one of your buddies!!!
Edited by MikeHulbert 9/18/2007 8:15 AM
|
|
|