MuskieFIRST | Lowrance Water Etching-Solutions? » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> Lowrance Water Etching-Solutions?

Message Subject: Lowrance Water Etching-Solutions?

e-hound

Posted 2/7/2006 5:59 PM (#176108)
Subject: Lowrance Water Etching-Solutions?

Posts: 22

Location: St James MN

Got some pretty bad etching on my 350a, factory service/replacement is cost prohibitive on an older unit. Anyone have any solutions which can lessen the problem. Can it be polished out somehow. I'm just looking for some improvement-not a miracle, but don't really want to experiment and make it worse. Thanks in advance.

e-hound

krisg

Posted 2/8/2006 9:28 AM (#176247 - in reply to #176108)
Subject: RE: Lowrance Water Etching-Solutions?

McGuiars makes a couple of products that work great. #17 clear plasic cleaner, #10 clear plastic polish, and # 18 clear plastic cleaner polish. Best is to use #17 to clean and then #10 to polish, #18 is just to maintain after that but usually is not needed.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread