|
|

Posts: 2026
| I have the 2017 Terrova. With the redesigned lift assist, you can no longer run your own transducer on the terrova prop right? I have not been able to find any modifications online. Any suggestions?
If not, does the Universal Sonar work better with a Hummingbird Helix or HDS Gen 3s?
I currently have a Gen 1 HDS 7 for the Universal sonar and it's not clear at all, so I will be upgrading if there's not a modification suggested above.
Thanks! |
|
|
|
Posts: 1209
| Can you take the lift assist stuff out so you have that channel back? That's what I would do, my terrova have been hooked to birds and Lowrances, never had an image issue, but I can tell you the temp sensor is wrong out of the box with terrova to Lowrance |
|
|
|

Posts: 2026
| No, I wouldn't mess with the lift assist. Plus, the channel is too shallow now for a Lowrance transducer cord now. Not sure about a Bird cord. I'm sure my clarity is just the HDS1. I'll try my Gen 3 one up front before buying anything. |
|
|
|
Posts: 1748
Location: Mt. Zion, IL | I have Gen 2 non touch units and a terrova. Mine reads the same as the lowrance transducer with the universal sonar and the temp is within 0.2 degrees of the rear when I fish in the local rivers for bass. The temperature of the entire water column is the same due to the discharge rates. I run the surface clarity on low, suppression off, and shallow water fishing mode of that helps. |
|
|
|

Posts: 1095
Location: Hayward, WI | What do you mean by your current depthfinder isn't clear? Do you have interference issues, or just not as much detail as you would like? |
|
|
|

Posts: 546
Location: MN | These guys have a solution, made with what looks like a coiled air hose, to keep transducer cables protected and out of the way. https://precisionsonar.com/products/
Edited by mtcook16 1/29/2018 3:25 PM
|
|
|