|
|
Posts: 425
| In the spring of 2008 I switched my fish finder unit. I took out the usual (the one that just comes with the boat). And I put on a Humminbird 595 GPS/combo.
Now I have that little Lowrance X47 TX just sitting around in my house. I don't have any of the cords any more though. Just the gragh. Does Lowrance sell the cords and the transducer seprate?
Is there anyway that I can mount it on the bow of the boat? Either place the transducer in the front or the back. I heard that placing it on the front is a lot better, because you would be reading the depth that is right under you and not 20 feet behind you.
Any advice would help, thanks! |
|
| |
|
Posts: 774
Location: South East Wisconsin | Mount the graph on the bow. Run the cord down the trolling motor shaft. Then mount the transducer on the bottom of the trolling motor. Thats how mine is and I have no problems.
S.Killips |
|
| |
|
Posts: 1663
Location: Kodiak, AK | Give it all a slow trial run before you hard mount it and take it out. I know two guys that installed a TM ducer in the garage, and the first time they deployed it, they either stretched it too far and messed up the install, or actually cut it. |
|
| |
