MuskieFIRST | Minn kota power driver problem » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Minn kota power driver problem

Message Subject: Minn kota power driver problem

Ytee

Posted 7/7/2014 9:15 PM (#719618)
Subject: Minn kota power driver problem

Posts: 1

I'm new to fishing and I just purchased a minn kota power drive v2 from bass pro shop. It seems to be working fine but when I deploy the motor in the water it will not lock in place. It appears that the locking pin will not go in place and may need to be adjusted. But I see no way to adjust it. Anyone have any suggestions.

VMS

Posted 7/7/2014 9:35 PM (#719623 - in reply to #719618)
Subject: Re: Minn kota power driver problem

Posts: 3508

Location: Elk River, Minnesota

hiya,

if you take off the right side plate you should be able to follow the linkage from the lock release lever to the locking bar to hold the motor down. my bet is there is a missing push nut that holds the linkage together...

steve

bassinbob84

Posted 7/7/2014 10:36 PM (#719636 - in reply to #719618)
Subject: Re: Minn kota power driver problem

Posts: 646

Location: In a shack in the woods

My older style powerdrive would do that sometimes. If I would push the release button again it would slip into place and lock.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread