MuskieFIRST | Lead pot, mold, wires » Buy , Sell, and Trade

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Buy , Sell, and Trade -> Lead pot, mold, wires

Message Subject: Lead pot, mold, wires

ChadG

Posted 6/5/2013 3:56 PM (#645018)
Subject: Lead pot, mold, wires

Posts: 440

The mold is a 3/4, 1, 1.5 and 2oz banana head jig mold that I use for making spinnerbait. I used a dremel to make a path for the wires. The wires are .051 for muskie spinnerbaits and the hooks are 7/0. The lead pot works fine.

$50 tyd

Edited by ChadG 6/5/2013 4:30 PM

Zoom - | Zoom 100% | Zoom + | Expand / Contract | Open New window

Click to expand / contract the width of this image

(DSC02000.JPG)

Attachments
----------------

DSC02000.JPG (181KB - 107 downloads)

musky chimes

Posted 6/6/2013 3:45 AM (#645102 - in reply to #645018)
Subject: heat and time?

Posts: 152

how much time does it take to melt the lead down with that ?

Edited by musky chimes 6/6/2013 3:47 AM

big bear

Posted 6/6/2013 5:44 AM (#645104 - in reply to #645018)
Subject: RE: Lead pot, mold, wires

Posts: 22

Location: chequamegan

I'll take it, check pms

PHISHMAN

Posted 6/6/2013 6:53 PM (#645276 - in reply to #645018)
Subject: Re: Lead pot, mold, wires

Posts: 47

I've got the same setup but altered to accept .062 thick wire forms and 8/0 hooks. Lead melts in 10 minutes. Tip heat the mold up by pour lead into it a few times without the wire and hook. If not the mold sometimes will not be hot enough to properly mold when pourinv the lead and you end up wasting a hook and wire form. Use a fluid bed and powder paint right afterwards to coat the lead.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread