MuskieFIRST | trolling motor plug » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> trolling motor plug

Message Subject: trolling motor plug

danmuskyman

Posted 1/19/2013 5:58 PM (#610793)
Subject: trolling motor plug

Posts: 633

Location: Madison, WI

I have a 24v Marineco plug that was previously wired with two sets of leads. one from each battery (A+A-, B+B-). The 24 volts was made with a jumper in the male end of the plug. one of the leads was faulty so i re-wired the 2 batteries to 24 volts and ran only one set of leads back to the bow. My question is can i still use this plug? If so do I just hook the leads to one set of terminals or what? (A+A-) for instance. Or will the jumper inside the male end ruin anything?

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread