Muskie Discussion Forums
| ||
Moderators: Slamr | View previous thread :: View next thread |
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> Abu Garcia C4 6600 part # question |
Message Subject: Abu Garcia C4 6600 part # question | |||
A_Stratus |
| ||
Posts: 19 Location: Lake St.Clair | Hello, Recently while fishing I had a snag and when trying to release the spool the thumb bar release cracked. Now it is stressed and does not release easily due to the fracture in the plastic. I tried looking for the part # in the schematic but can't seem to find it. Any help would be appreciated. There is a part # for the thumb rest on the top of the can though. I put a picture up of the fracture as well. Also, does anybody recommend a source to order the part from? Thanks Attachments ---------------- P1110383.JPG (148KB - 188 downloads) P1110384.JPG (128KB - 178 downloads) | ||
RyanJoz |
| ||
Posts: 1711 Location: Mt. Zion, IL | I would epoxy it and hope it holds. Garcia does not sell just the thumb bar. You will have to buy a complete frame and they run about 55 dollars. | ||
phishmasta |
| ||
Posts: 115 | try daves reel service, he carries thousands of parts and just might have one in stock. | ||
PIKEMASTER |
| ||
Location: Latitude 41.3016 Longitude 88.6160 | I have one email for info $15.00 cost plus shipping I stock ABU, SHIMANO, and DAIWA parts. [email protected] | ||
RyanJoz |
| ||
Posts: 1711 Location: Mt. Zion, IL | PIKEMASTER - 11/12/2012 10:12 PM I have one email for info $15.00 cost plus shipping I stock ABU, SHIMANO, and DAIWA parts. [email protected] How do you remove the frame pin to install the thumb bar? Isn't it brazed to the sides of the frame? | ||
PIKEMASTER |
| ||
Location: Latitude 41.3016 Longitude 88.6160 | RyanJoz - 11/13/2012 7:18 AM PIKEMASTER - 11/12/2012 10:12 PM I have one email for info $15.00 cost plus shipping I stock ABU, SHIMANO, and DAIWA parts. [email protected] How do you remove the frame pin to install the thumb bar? Isn't it brazed to the sides of the frame? Your right U can't remove that to replace it I have a Frame with the thumb bar for $15.00 plus Shipping | ||
A_Stratus |
| ||
Posts: 19 Location: Lake St.Clair | Thank you everyone for the responses. I just JB welded the piece and seems like it's going to hold up. Thank you for the offer Pikemaster, if it fails, I will be sure to contact you Aaron | ||
Jump to page : 1 Now viewing page 1 [30 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
Copyright © 2024 OutdoorsFIRST Media |