MuskieFIRST | shoot thru hull transducer question » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> shoot thru hull transducer question

Message Subject: shoot thru hull transducer question

muskymartin67

Posted 4/6/2011 8:18 PM (#491139)
Subject: shoot thru hull transducer question

Posts: 787

Location: Delavan, WI

what type of adhesive/epoxy should be used so the signal isnt interfered with - i removed my old lowrance transducer that was installed in the hull and went to a newer unit- would like to place in the same location as Im already putting another ducer off the transom of the boat any help/suggestions appreciated

Chasin50

Posted 4/6/2011 8:29 PM (#491146 - in reply to #491139)
Subject: RE: shoot thru hull transducer question

Posts: 380

Location: Michigan

Martin,

Lowrance actually sells epoxy in their accessories store through LEI. But I honestly dont think it matters. If you buy some marine grade epoxy from any boat supply store, it should work fine.

muskymartin67

Posted 4/6/2011 8:54 PM (#491153 - in reply to #491139)
Subject: Re: shoot thru hull transducer question

Posts: 787

Location: Delavan, WI

Thanks Chad- have you done this and know for sure? I do have some 10 min set time super strength clear epoxy I was thinking about using just thought Id get another opinion before I use it and then have to remove because its not getting a good "ping"

lambeau

Posted 4/7/2011 7:53 AM (#491209 - in reply to #491139)
Subject: RE: shoot thru hull transducer question

i've used basic 2-part epoxy on 4 different boats. worked fine every time.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread