|
|
Posts: 1504
Location: Oregon | Anyone found an easy way to remove etex from lures that need to be refinished?
thx.
Jed |
|
| |
|
Posts: 474
| Heat gun, works great, but watch the fumes. Be sure to ventilate.
Good Luck
Kevin |
|
| |
|
Posts: 615
Location: Madison, WI | Riverman,
Does it need to be completely stripped? if not a sanding sponge and some elbow grease will knock down high spots and even everything out enough to reprime and start over. Just got doing it to a devcon2T cleared bait that got away from me and it's on the wheel now and looks great.
MS |
|
| |
|
Posts: 619
Location: Verona, WI | Heat gun but it's nasty that's for sure. |
|
| |
|
Posts: 40
Location: manchester,england | i tend to use a stanley knife blade and peeling them like an orange almost gets most of it off |
|
| |
