|
|
Posts: 148
Location: Excelsior, MN | Not limited to Ranger boats... Check out the attached photos of Spencer Berman's tandem/side-by-side Casting Deck Box extension for the back of his Tuffy 2060.
Total area is 62" L , 14 1/2" W, 12 1/2"H split into two deck boxes.
Photos are prior to non-slip top application.
[email protected]
(Spencer Berman Side By Side Tandem Open 12-3-09 compressed.JPG)
(Spencer Berman Side by Side Tandems Closed 12-3-09 compressed.JPG)
Attachments
----------------
 Spencer Berman Side By Side Tandem Open 12-3-09 compressed.JPG (47KB - 214 downloads)
Spencer Berman Side by Side Tandems Closed 12-3-09 compressed.JPG (41KB - 223 downloads)
|
|
| |
|
| I've seen these boxes on here many times in the past and love them but it would be helpful to people interested in them to know about how much these custom boxes would cost. I'm sure many are interested in price. Thank you. |
|
| |
|
Posts: 32880
Location: Rhinelander, Wisconsin | Call Just Encase and ask, the specific deck you need may cost more or less than one in another boat because of width, height, and your requests in customizing the box. The website banner is displayed on several pages right here on MuskieFIRST! |
|
| |
|
Location: Twin Cities | Guest - 12/16/2009 6:03 PM
I've seen these boxes on here many times in the past and love them but it would be helpful to people interested in them to know about how much these custom boxes would cost. I'm sure many are interested in price. Thank you.
It would take less button pushes on a phone to call and ask...lol. |
|
| |
|
Posts: 2378
| Guest - 12/16/2009 6:03 PM
I've seen these boxes on here many times in the past and love them but it would be helpful to people interested in them to know about how much these custom boxes would cost. I'm sure many are interested in price. Thank you.
Got a buddy that was considering getting his dad a custom Justencase box like this for the back of his Ranger. Not sure on the exact dimensions, but I think it was very similar.
$900 was quoted to him |
|
| |
|
Posts: 32880
Location: Rhinelander, Wisconsin | For a Lund or a Tuffy, it could be more...or less. Again, it's important to call Bob for a quote on your rig and give him the exact dimensions you are looking for to get an accurate quote.
If you are, for instance, looking to use the Just Encase rear module in the place of the Tuffy Esox Deep V rear deck module, the cost of both is about identical if you keep the dimensions the same; about $850.00. |
|
| |
|
Posts: 148
Location: Excelsior, MN | As noted in Steve W.'s posts, if you are interested in a Custom ClearView Box or Casting Deck Box all you need to do is call me (even toll free), send a PM, or email, or even stop by the shop if you are local. There are way too many high cost variables that impact pricing. IMO, that is why they are called Custom. For the many of you already contacting me for a custom quote on a daily basis, I'm confident you would agree I am responsive.
Bob Schmitt
952 401-8909 or 888 401-8909
[email protected]
www.justencase.com |
|
| |
