MuskieFIRST | Bow Mount Transducer on Slide Type Trolling Motor Question » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> Bow Mount Transducer on Slide Type Trolling Motor Question

Message Subject: Bow Mount Transducer on Slide Type Trolling Motor Question

Fish Fry Guy

Posted 10/5/2009 11:24 PM (#403325)
Subject: Bow Mount Transducer on Slide Type Trolling Motor Question

Posts: 56

Location: Maplewood, MN

I have a "slide" type trolling motor vs. the "flip" type and do not have a universal transducer. I have had some problems mounting my transducer to the trolling motor and having the cord get wrapped up, cut up, etc when pulling up and putting down the trolling motor. Any suggestions on this? Any mounting tricks I should try or is this just a case of be more careful when loading/unloading the motor and watch the cord twist? Thanks in advance.

sworrall

Posted 10/5/2009 11:26 PM (#403326 - in reply to #403325)
Subject: Re: Bow Mount Transducer on Slide Type Trolling Motor Question

Posts: 32886

Location: Rhinelander, Wisconsin

Zip ties top and bottom, allowing just enough slack to keep things tidy but not over-tight.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread