|
|
Posts: 706
Location: Richland Center, WI. | I have for sale a Michigan Wheel three blade aluminum prop. Purchased at Cabelas a couple years ago for a 2004 Mercury 90hp 4 stroke motor. It is a 13 1/4 diameter/17 pitch right handed prop. Part number 992104. I'm sure it will fit other motors but should look up the number to be sure. Some paint chips at the end of the blades but no cracks or bends. Used 2 months. New was $119, sell for $75obo plus shipping or can pick up near Richland Center or Madison WI. (good excuse to hit the Mad Chain) PM or email [email protected] if interested. Can send pictures if needed. Prop does not include the hub kit.
Thanks, Ken |
|
| |
|
Posts: 706
Location: Richland Center, WI. | $75obo shipped! |
|
| |
|
Posts: 706
Location: Richland Center, WI. | Can anyone use this prop? Make an offer!
Ken |
|
| |
|
Posts: 13
| I'm interested, but I don't know if it would fit my outboard.
Any ideas on a site that would have that info?
Dave Dorazio |
|
| |
|
Posts: 706
Location: Richland Center, WI. | Hi Dave,
I would go to the Michigan Wheel site and look up your motor and see if the prop fits. It is a Vortex prop with a part number of 992104. This is 13 1/4 diameter and 17RH pitch. The prop does not have splines in it but uses the hub kit to attach it to the motor. Wish it was early July, I will be in Hayward and you could check it out.
Ken |
|
| |
|
Posts: 3514
Location: Elk River, Minnesota | Dave,
What do you run for a motor?
Steve |
|
| |
|
Posts: 13
| I run a 2007 Mercury 60 hp. 4 stroke.
Dave Dorazio |
|
| |
|
Posts: 706
Location: Richland Center, WI. | Dave,
I checked the Michigan Wheel site. It does not look like this prop will work for you.
Ken |
|
| |
|
Posts: 13
| Ken,
Thanks anyway.
Dave |
|
| |
|
Location: SE Wisconsin | PM sent! |
|
| |
|
Posts: 706
Location: Richland Center, WI. | Got it and sent a reply.
Ken |
|
| |
