|
|
Posts: 605
Location: Marshfield, WI | I have a new LeLure creeper that rolls/spins when retrieved. Anyone know how to tune it? If doing it is easier than describing it, I could bring it to the Milw. show or the swap meet.
Krishna
Edited by k-bob 2/3/2008 12:38 AM
|
|
|
|
Posts: 3518
Location: north central wisconsin | Krishna, bring it over. Probably just needs wings twisted downward or bent in, or both, somewhat. If they are screwed on in the right place, tuning should be a cinch.
Edited by Reef Hawg 2/3/2008 10:38 AM
|
|
|
|
Posts: 190
| Here are some pics that will help you. First pic shows a good equal spread........Second pic shows incorrect twist on wings.......Third shows good starting point for wings.........Keep in mind both wings need to be bent the same to achieve an equal oscilation ( walk evenly).
As you can see the bottom of the wing in the correct site pic is pointing nearly straight down....This is a great starting point.
More forward position on the bottom of the wing causes more bite and a wider walk where straight down or slightly back causes a tighter or softer walk.........I would guess your wings twist is set to far forward and they are not twisted the same.......Good Luck..........................Doug Bradley
Attachments ----------------
100_0819.JPG (20KB - 125 downloads)
100_0822.JPG (23KB - 137 downloads)
100_0823.JPG (24KB - 125 downloads)
|
|
|
|
Posts: 605
Location: Marshfield, WI | Looking at Doug's pics, I think Jason might be right. I think the wings just need to be angled downwards a bit. I'll give that a try and if it doesn't work, then I'll stop by sometime or maybe we can meet up somewhere on the water once the season is open. Someone is sending me a file on tuning creepers, so hopefully that will help too.
Thanks guys,
Krishna |
|
|