|
|
Posts: 169
| I ruined my Do-it mold and need to know, is there any material I could use to fill-in the screwed up area that will hold up to the heat of the lead? Thanks.
Brad |
|
| |
|
Posts: 327
Location: In the slop! | Brad, where is the damage? I might be able to weld it and rework the area. You might post a picture. I'm not sure if there would be any other options. |
|
| |
|
| Get some J Weld from a hardware store. It will hold up for quite a while. Works for me.
Dick |
|
| |
|
| I meant JB Weld. Sorry for any confusion.
Dick |
|
| |
|
Posts: 169
| JB Weld might work. I need to fill in an area where I drilled. Thanks. |
|
| |
|
| Try Marine-Tex |
|
| |
|
| Hot sure how handy you are with MAPP Gas but you can get braizing sticks from Low's and Home Depot to fill it back in with new material. USE CAUTION!!!!!!!!!!!!!!!!!!!!!!!!!!!! |
|
| |
|
Posts: 169
| Thanks for the ideas. I took the easy route, I had a guy cut me a custom mold.
Brad |
|
| |
