MuskieFIRST | Check your bilge sonar transducers » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Check your bilge sonar transducers

Message Subject: Check your bilge sonar transducers

ESOX Maniac

Posted 4/29/2007 7:34 PM (#253544)
Subject: Check your bilge sonar transducers

Posts: 2753

Location: Mauston, Wisconsin

Just started getting ESOX Maniac ready for the 2007 season & the new Humminbird 997. So I was checking out the bildge to see what was up down there. Well I discover two transducers - both loose! Now I know why the Eagle was losing bottom. They were both installed with a soft rubbery adhesive. I think the other transducer is the bottom alarm unit.

Now the task begins- clean out the bilge- prepare the mounting surface(s), reinstall both old transducers and the new one for the Humminbird. Any advice on epoxy, etc. would be greatly appreciated.

Al

Edited by ESOX Maniac 4/29/2007 7:35 PM

sworrall

Posted 4/29/2007 9:52 PM (#253563 - in reply to #253544)
Subject: Re: Check your bilge sonar transducers

Posts: 32886

Location: Rhinelander, Wisconsin

A two part 5 minute epoxy will do the job!

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread