MuskieFIRST | Hydraulics won't work. » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Hydraulics won't work.

Message Subject: Hydraulics won't work.

Lightning

Posted 11/14/2006 3:46 PM (#220902)
Subject: Hydraulics won't work.

I replaced a relay and still getting a click where to look next.

jtroop

Posted 11/15/2006 5:37 PM (#221071 - in reply to #220902)
Subject: RE: Hydraulics won't work.

Posts: 177

Location: Cohasset, MN

Are you talking about your tilt/trim ?? If so - In my case it was a bad pump motor.

mercmech

Posted 11/19/2006 7:12 AM (#221633 - in reply to #220902)
Subject: RE: Hydraulics won't work.

Posts: 49

Location: St. Croix River, Mille Lacs,

PLease be more specific on your initial issue and other details. Perhaps some could help you

lightning

Posted 11/21/2006 9:58 AM (#221906 - in reply to #220902)
Subject: RE: Hydraulics won't work.

Sorry guys. The hydraulics are on the trim and tilt. The motor in an '86 150hp Envirude. I have lifted the motor after I loosened the hydralic cap.

Esox chaser

Posted 11/21/2006 12:11 PM (#221924 - in reply to #220902)
Subject: RE: Hydraulics won't work.

Posts: 154

Location: Appleton, WI

A lot of times there is an up relay and a down relay. I had a Cobra on a boat and the up and down relay were in a box with a fuse and you had to replace the whole thing when a relay went bad.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread