MuskieFIRST | floor in the boat » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> floor in the boat

Message Subject: floor in the boat

Bruce

Posted 3/8/2006 7:54 PM (#181450)
Subject: floor in the boat

Any tips for putting a plywood floor in an aluminum boat? Measuring? Does everyone mitre/angle the edges of their sheets to have it fit flush against the hull? rather than just the edge rest against the hull? Tips would be appreciated. Thanks. Just need a floor for standing on, no pedestal seats to be attached.

Slamr

Posted 3/8/2006 10:20 PM (#181469 - in reply to #181450)
Subject: RE: floor in the boat

Posts: 7105

Location: Northwest Chicago Burbs

use wolmanized wood (sp?), and use carpet on it, stapling the carpet to the wood.....while wrapping it under the bottom and you'll not have to worry about edges against the hull.

muskiecowboy

Posted 3/12/2006 7:15 PM (#181952 - in reply to #181450)
Subject: RE: floor in the boat

Posts: 85

I'm putting in a floor in my 69 mirrorcraft 16'. I'm using a composite wood product for decks. It's light and won't rot or warp and already has tread pattern embossed in it. Also no finish needed. May not suit your appl. Just thought I'd pass it on. Thanks and good fishing.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread