MuskieFIRST | Power Handle on a calcutta ct400 » General Discussion

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> General Discussion -> Power Handle on a calcutta ct400

Message Subject: Power Handle on a calcutta ct400

BenR

Posted 12/11/2005 10:06 AM (#168391)
Subject: Power Handle on a calcutta ct400

Hello, I just put a power handle on an older ct400 because the ratio is a bit slower than I like...does it make a difference? It does seem to make the reel wobble a bit, but that is just reeling it with no line or anything on it. It is being used on a 7'10" diamonback magnum minnow rod by dadson rods... it will used to through grandma..jakes...and the like...any experience with the power handles on these rods...Ben

sally

Posted 12/12/2005 9:29 AM (#168484 - in reply to #168391)
Subject: RE: Power Handle on a calcutta ct400

I use one on my 400, have for years.

I really like it for cranks and bucktails, makes reeling easier for baits with drag.

I usually palm that reel or use the foregrip, so I don't notice much wobble when I'm fishing. If I was using it by holding the handle and using the "trigger" on the reelseat I'm sure it would wobble a lot.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread