MuskieFIRST | Stripping Envirotex off a plastic bait. » Basement Baits and Custom Lure Painting

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Random quote: Muskies are nasty. They stink. They taste bad. They are hard to catch and will disappoint even the most devoted angler. The lures required cost more than some women's jewelry. The rods and reels require a remortgage of the house. The boat is always worth more than the tow vehicle. Sure beats the hell out of golf.
- (Added by: sworrall)

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] More Muskie Fishing -> Basement Baits and Custom Lure Painting -> Stripping Envirotex off a plastic bait.

Message Subject: Stripping Envirotex off a plastic bait.

NUT

Posted 2/7/2016 4:28 PM (#803471)
Subject: Stripping Envirotex off a plastic bait.

How does a guy get envirotex off a hollow plastic bait without ruining it? I've always done it with a heat gun on woods baits.

rougarou

Posted 2/7/2016 6:58 PM (#803500 - in reply to #803471)
Subject: RE: Stripping Envirotex off a plastic bait.

Posts: 102

why do you have to take it off can you fill if some has chipped or just put another coat over and repaint

MRichardson

Posted 2/10/2016 9:16 AM (#804027 - in reply to #803471)
Subject: RE: Stripping Envirotex off a plastic bait.

Get under it with a razor and try to peal it off is about the best luck I've had. Screwed a few up trying to sand

Edited by MRichardson 2/10/2016 9:17 AM

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread