MuskieFIRST | Looking for advice on spraying metallics » Basement Baits and Custom Lure Painting

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Random quote: Muskies are nasty. They stink. They taste bad. They are hard to catch and will disappoint even the most devoted angler. The lures required cost more than some women's jewelry. The rods and reels require a remortgage of the house. The boat is always worth more than the tow vehicle. Sure beats the hell out of golf.
- (Added by: sworrall)

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] More Muskie Fishing -> Basement Baits and Custom Lure Painting -> Looking for advice on spraying metallics

Message Subject: Looking for advice on spraying metallics

Musky 33

Posted 6/21/2015 12:24 AM (#773369)
Subject: Looking for advice on spraying metallics

Posts: 30

I'm a beginner trying to spray created wicked pearl gol and copper but when I spray it either doesn't spray or comes out in too large of quantity. Any suggestions? Air pressure or thinning out? I tried thinning but don't know if I have the viscosity right. Thanks for any advice. Jeff

genesisperformance

Posted 6/22/2015 8:02 PM (#773595 - in reply to #773369)
Subject: Re: Looking for advice on spraying metallics

Posts: 403

Location: Lakeville, MN

what gun are you using? what size needle? i have better luck with a .5mm needle in my eclipse

Musky 33

Posted 6/25/2015 11:04 PM (#774095 - in reply to #773369)
Subject: Re: Looking for advice on spraying metallics

Posts: 30

I have an Iwata eclipse also but mine has a .35mm needle

Edited by Musky 33 6/25/2015 11:07 PM

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread