Muskie Discussion Forums
| ||
Moderators: Slamr | View previous thread :: View next thread |
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> boat wiring big short wires fried |
Message Subject: boat wiring big short wires fried | |||
toothycritter88 |
| ||
Got my boat out of storage and found a massive short and melted a ton of wires in my boat. Does anyone know where i could get a complete wiring harness for a 1991 princecraft? | |||
muskyhunter47 |
| ||
Posts: 1638 Location: Minnesota | Call princecraft ? | ||
toothycritter88 |
| ||
They only keep parts for the current year and 5 previous years. | |||
horsehunter |
| ||
Location: Eastern Ontario | Boat layouts are fairly constant and I would think the harness from a current like sized model would work. Hopefully only boat wiring involved and not motor and electronics. | ||
toothycritter88 |
| ||
This picture comes from the transom and goes into the motor. But i cant even find where in the boat it goes to Attachments ---------------- PicsArt_1426513113245.jpg (132KB - 135 downloads) | |||
scmuskies |
| ||
Posts: 258 Location: Mayville, WI | That picture looks a bunch more like outboard wires than a boat harness, especially if you can't find where it goes in the boat... Call around to local outboard service centers / dealers (Johnson?), but I'd be very worried about further internal motor damage looking at that. sc | ||
toothycritter88 |
| ||
Before i noticed that i started it up in the driveway and it started and ran fine. Then i saw that and immediately shut it off | |||
Propster |
| ||
Posts: 1901 Location: MN | I have to ask - assuming the last time you used it everything was okay and in good working order, then you put the rig in storage, and you take it out of storage to find this - who/when/how would it have been started or run to cause a short that would have caused this type of melting or damage? | ||
toothycritter88 |
| ||
Yeah everything was fine when i put it away. It was hooked up to a battery tender for the winter. I dont know if a mouse chewed through the wires or what. I havent found one. I dont know what could have happened | |||
tyler k |
| ||
Posts: 409 Location: Almond, WI | This last June, my '96 Smokercraft nearly started on fire. The only reason I caught it was because I had an extra cup of coffee that morning and pulled into a gas station, mostly to pee, but got gas and do my walk around (check bearings/trailer tires, etc.) and smelled that electrical fire smell and see smoke starting to come out of my battery compartment. I quickly unhooked the battery and extinguished the battery box and the aft below deck access. What happened was a screw loosened on a metal rear deck support and the wiring harness worked its way under, cut through the insulation and shorted out. Fortunately we saved the wiring harness, only a couple spots needed to be repaired. Now we rigged up a master fuse system to hopefully prevent this, besides tightened the screws and added some new insulation around the harness. Not fun. Wiring harnesses seem pretty close to universal so you can probably get one to work. Maybe Princecraft has a schematic for you to work from. | ||
Propster |
| ||
Posts: 1901 Location: MN | Ahh, that sucks. I guess it's possible then unless the batteries are pulled and hooked up separately to always have that risk | ||
kjgmh |
| ||
Posts: 1089 Location: Hayward, WI | The 2 big wires go to your trim pump, the smaller wires are for your trim sender. You might make sure that you have all the ground wires hooked up on your battery, have seen something similar when main ground wires where not hooked up to the battery. If it is just the wires shown in picture they are not part of the wire harness, they are separate. | ||
Jump to page : 1 Now viewing page 1 [30 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
Copyright © 2024 OutdoorsFIRST Media |