MuskieFIRST | 06 ranger ignition pad? » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> 06 ranger ignition pad?

Message Subject: 06 ranger ignition pad?

Peaches

Posted 6/29/2014 6:56 PM (#718364)
Subject: 06 ranger ignition pad?

Posts: 273

I was running across the lake today in some pretty good waves when the power killed to my big motor. After messing around for a bit, I remembered I had the back up key switch and got the motor fired again.

The question I have is where should I be looking for my problem? The key pad still lights up and all other functions besides starting work. Is the pad shot or should I be looking for a bad fuse or bad connection? Any help would greatly be appreciated.

Jeff

toddb

Posted 6/30/2014 7:58 AM (#718423 - in reply to #718364)
Subject: RE: 06 ranger ignition pad?

Posts: 379

Location: Thief River Falls MN

Not sure if this will help, but... Check and see if any of the keypad lights are staying on. If so hold that button down until it goes off. On the newer pads at least, these buttons are circuit breakers and can be reset by holding down.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread