MuskieFIRST | Trolling setups on esox mags?? » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Trolling setups on esox mags??

Message Subject: Trolling setups on esox mags??

MuskyMulisha

Posted 11/7/2013 7:47 PM (#672479)
Subject: Trolling setups on esox mags??

How do some of you guys set up your tuffy esox mag boats for rod holders?? Thanks Guys

sworrall

Posted 11/7/2013 8:00 PM (#672480 - in reply to #672479)
Subject: Re: Trolling setups on esox mags??

Posts: 32910

Location: Rhinelander, Wisconsin

30" handrails.

MD75

Posted 11/8/2013 2:40 PM (#672554 - in reply to #672479)
Subject: Re: Trolling setups on esox mags??

Posts: 682

Location: Sycamore, IL

Down east Salty S-10 clamp on rod holders fit right on the gunwhale and can be positioned where you need them. I use two toward the front for board/ out rods and two toward s the back for down rods. I was also able to get one clamped on the transom for my propwash rod...but just barely. I run an esox ltd tiller so not sure if the mag's transom is different or not. Good luck!

Bucky_Musky

Posted 11/9/2013 5:00 AM (#672596 - in reply to #672479)
Subject: Re: Trolling setups on esox mags??

Posts: 152

I have the stinger, similar to the Esox Mag, and I have just used scotty rod holders with the extension piece to get it above the edge with room to play with. I think the handrail is probably the best looking option though.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread