|
|
Posts: 548
Location: MN | My tilt and trim switch up front on the pro v doesn't work.
Been trying to track it down with no luck.
Anyone know where I can get a wiring diagram.
On line would be great.
Will try lund today also.
thanks
Nick
Edited by Nick59 8/15/2012 8:18 AM
|
|
| |
|
Posts: 128
| There shouldn't be much to it at all. The harness is likely just a tie in with the trim wires running to the binnacle.
Pull your switch and touch the wires together after removing them....If the switch is bad you will get up/down depending on which wires you touch together. If so, then you know it's the switch. |
|
| |
|
Posts: 548
Location: MN | Thanks will try that tonight after work.
Nick |
|
| |
|
Posts: 548
Location: MN | Well just getting back to this and touching the wires together did nothing. So I'm assuming should try and trace the wires back to the source. This is a tiller.
Nick |
|
| |
|
Posts: 76
| Did you have a new motor hung on your boat recently? I changed my motor out and the trim switches were not compatable according to the tech. |
|
| |
|
Posts: 1096
Location: Hayward, WI | Should be Red power, green down, blue up. |
|
| |
|
Posts: 548
Location: MN | Still the 94 Merc 75. Will trace the wires back when I get some free time ... and it's not raining.
Nick |
|
| |
