Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Moderators: Slamr

View previous thread :: View next thread
Jump to page : 1
Now viewing page 1 [30 messages per page]

Muskie Fishing -> Lures,Tackle, and Equipment -> Ressurecting a broken rod?
 
Message Subject: Ressurecting a broken rod?
Farmer Rick
Posted 1/25/2012 8:59 PM (#534865)
Subject: Ressurecting a broken rod?





Location: Not far enough north!
I used to use a 6'10" rod for throwing gliders and WTD lures but with the increasing length of my other rods I have trouble feeling comfortable throwing such a short rod and my gliders are getting neglected. I dont really like using the long rods for these lures either.

So I have an old fig rig that was 7'6" but thanks to a friend is now about 7'4". I am just wondering where I can find a new tip the right size to fit the rod where it is broken off. Of course the rod did not break cleanly and has a frayed end, so should I cut the end cleanly and if so with what? Also is it even worth trusting a rod that has been broken already?
Thanks
Rick
Landonfish
Posted 1/26/2012 5:54 AM (#534892 - in reply to #534865)
Subject: Re: Ressurecting a broken rod?




Posts: 360


Www.mudhole.com. I would cut your rod tip even and then put the new tip on and it will be good as new.
Tackle Industries
Posted 1/26/2012 6:32 AM (#534898 - in reply to #534865)
Subject: Re: Ressurecting a broken rod?





Posts: 4053


Location: Land of the Musky
2x for www.mudehole.com Just get some calipers and measure your "new" tip diameter so you can fit it with the correct tip internal hole diameter. They have a full selection of micro to monster saltwater tips for rods.
bowhunter29
Posted 1/26/2012 8:44 AM (#534914 - in reply to #534865)
Subject: Re: Ressurecting a broken rod?





Posts: 908


Location: South-Central PA
Use a dremel tool to trim the tip back. Make sure you trim back to the last spot it cracked.

Like James said, use calipers to measure the tip in mm and then give Mudhole a call. You'll probably need a tip with a ring diameter of 8mm, most running guides and tips on musky rods are 8's.

jeremy
muskie! nut
Posted 1/26/2012 9:04 AM (#534917 - in reply to #534865)
Subject: Re: Ressurecting a broken rod?





Posts: 2894


Location: Yahara River Chain
I hope folks realize that you need a dial calipers, not just a caliper.
Farmer Rick
Posted 1/26/2012 3:54 PM (#534995 - in reply to #534865)
Subject: Re: Ressurecting a broken rod?





Location: Not far enough north!
Thanks Guys, I will check out mudhole, I will trim the rod and measure with caliper, ive got a good one for reloading...
Jump to page : 1
Now viewing page 1 [30 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)