MuskieFIRST | Trolling motor modification » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Trolling motor modification

Message Subject: Trolling motor modification

bigroo

Posted 2/26/2011 10:31 AM (#483965)
Subject: Trolling motor modification

Posts: 60

Location: Poca, West Virginia

Has anyone ever turned the control head around on there transom mount trolling motor so it could be used on the bow or on the side? I assume there are just two wires running down to the motor that could twist 180 degrees. I have a Endura 55c that appears to have just one screw that goes through the head and the shaft. Can you remove the screw and just turn the head 180 degrees and reinstall the screw?

rudy

Posted 2/26/2011 10:35 AM (#483966 - in reply to #483965)
Subject: RE: Trolling motor modification

Posts: 131

yup,thats all you gotta do is remove the bolt that holds the head on,turn it and replace the bolt.should take about a minute.

bigroo

Posted 2/26/2011 11:51 AM (#483976 - in reply to #483966)
Subject: RE: Trolling motor modification

Posts: 60

Location: Poca, West Virginia

Thank you very much.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread