MuskieFIRST | I think I bent my boat?? » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> I think I bent my boat??

Message Subject: I think I bent my boat??

Muskie4Life

Posted 7/5/2010 1:46 PM (#448606)
Subject: I think I bent my boat??

Posts: 105

I think I messed my boat up on Thursday. I hit a huge wake while at full speed and we hit pretty hard. Didn't think much about it until I was packing up to leave the lake and noticed that the interior panel on port side was pulled away from the gunnel. I finaly had a chance to look at it today and I can not bend it back in place. After further inspection I found a big hump in my floor in front of where you step up to the front casting deck. I'm guessing I must have tweeked the hull of the boat out of shape. I can't notice anything bent from looking at the boat from the outside. I have a Tracker Targa 17.

Anyone have any ideas about this, will it be a problem?

Out of shape

Posted 7/5/2010 7:52 PM (#448649 - in reply to #448606)
Subject: RE: I think I bent my boat??

Possible... If so I would contact your insurance carrier immediately. Damage on the water should be covered. No different than hitting a log, etc. Let them buy you a new hull or have it repaired by a factory authorized repair shop. That's why you have boat insurance.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread