|
|
Posts: 32
Location: Minnesota | My transducer broke between the head and the mounting swivel. I was thinking about drilling and pinning it and using some epoxy. Has anyone had any success or failure with this type of repair that might help me out? |
|
| |
|
| Try some JB Weld...I think that stuff fixes everything. |
|
| |
|
Posts: 95
Location: LOTW every chance I get | I tried epoxy on mine. Held for a while but eventually failed. I ended up drilling a couple small holes on either side of the break and running safety wire across the break to reinforce the repair. Still holding after a year and a half. |
|
| |
|
| I would replace it, a tranducer is relatively inexpensive. A repair job may hold for a while, but you never know when it will fail. Not worth being on the water and having it fail, only to leave you without the use of your electronics... |
|
| |
