MuskieFIRST | Epoxy on holo finish » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> Epoxy on holo finish

Message Subject: Epoxy on holo finish

Cast

Posted 8/31/2008 8:28 AM (#334187)
Subject: Epoxy on holo finish

Here is a question for you tackle masters. I have an 8" Jake with a holo finish. The holo is peeling off. I glued it, but there are loose ends. I was advised to apply epoxy to the lure. (To seal it?) I need to know over what surfaces I should apply the epoxy? Just the loose ends? All holo edges? The whole holo finish?
Thank you for any help.

Trolling Thunder

Posted 8/31/2008 9:41 AM (#334193 - in reply to #334187)
Subject: RE: Epoxy on holo finish

Posts: 390

Location: Ohio

I am a rookie to baitmaking, (but for my .02 cents) I applied epoxy to a grandma holo that was peeling and it has worked so far.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread