|
|
Posts: 697
Location: Minnetonka | I know this is a shot in the dark, but does any one have some trouble shooting tips for when your unit just all-of-a-sudden says "GPS module not responding."?
The units are X-111 and X-110, and both run off the same puck, which is mounted on the back right panel of a Ranger tiller... and we've already tried switching out the puck.
This all happened after we pressure washed the boat... the units were taken out for washing. Has anyone had problems with the connectors/cables getting wet?
Any help would be greatly appreciated. Thanks!
Andy
|
|
| |
|
Posts: 7090
Location: Northwest Chicago Burbs | See if there is a downloadable software update for the PUCk for the units. Was having the same problem. OR, make sure that all power is going to the puck. |
|
| |
|
Posts: 218
| On several occasions, I have blown a fuse because I got water into a connection while using a pressure washer. I would check the fuse on the puck's power input.
Edited by Southshore 7/11/2008 10:56 AM
|
|
| |
|
| A freind of mine had a similliar problem and his puck connector was corroded
at the unit head due to power being constantly supplied on that line. just something
to check? |
|
| |
|
Posts: 734
Location: Watertown, MN | Try a different GPS cable from the graph to the Module. I have seen one why connector go bad and one cable extension go bad.
Troyz |
|
| |
|
Posts: 697
Location: Minnetonka | Thanks for the help in a pinch fellas. Good luck this weekend! |
|
| |
|
Posts: 218
| Did you find and solve the problem?
Edited by Southshore 7/12/2008 11:55 AM
|
|
| |
