Muskie Discussion Forums
| ||
Moderators: Slamr | View previous thread :: View next thread |
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> General Discussion -> Trolling Question |
Message Subject: Trolling Question | |||
Bull![]() |
| ||
Planning on running 6 baits behind the boat this weekend: 2 flying far out on boards far from the boat, 2 flying on boards inside, and two down rods. Dumb question though, what do you do when an inside board rod goes off with a fish? I'm shooting big this weekend, so a better question is, what do we do when a 55"er takes the inside board bait? Thanks! Bull | |||
Big Perc![]() |
| ||
Posts: 1188 Location: Iowa | Chinese Fire Drill... Big Perc | ||
Shep![]() |
| ||
Posts: 5874 | Pull the down rod on that side, and reel in the fish and net it! Simple, right Wade? | ||
J.Sloan![]() |
| ||
Location: Lake Tomahawk, WI | Done this many times. Keep the boat in a forward motion, just enough to keep pressure on the fish yet not to drag it. Your partner can clean the down rods while the board is being brought to the boat. I usually slightly turn the boat in the opposite direction of the side that the board was on, bringing it directly in back of the boat, then straightening back out. Chinese fire drill, yes. Even better when an outside board gets ripped. J.Sloan | ||
tuffy1![]() |
| ||
Posts: 3242 Location: Racine, Wi | The other thing you can do, is just run 2 board rods, then run the boat rods clean, and 2 down rods. Just make sure you have different lengths of rods for your boat and down rods, and that should give you a good spread. Other than that, the boys ahead hit it perfect. Oh yeah, and the first thing you do when the rod gets ripped is say FISH ON!!! Yeah baby!!! | ||
MuskyHopeful![]() |
| ||
Posts: 2865 Location: Brookfield, WI | Joel likes to troll. ![]() Kevin Too much? | ||
Kingfisher![]() |
| ||
Posts: 1106 Location: Muskegon Michigan | They covered it well. I would clear both down rods though cause you never know which side she is going to end up on. Kingfisher | ||
Reef Hawg![]() |
| ||
Posts: 3518 Location: north central wisconsin | Do you guys tend to start out with a 'set' of the same type of lure/same line length, then switch from there??? I usually do that, thinking if I see fish caught by others, I can switch up the whole set. I end up switching one or two though, quite soon, and end up with a varied set. Just wondering what others do... | ||
woodieb8![]() |
| ||
Posts: 1530 | we normally run compatible baits for speed and colors vary till we contact fish. the big thing with multiple rods is when the fish are off and guys put out funky stuff. when they go they miss the bite. always leave your meat and potato baits out.. just change a couple at a time | ||
Grunt Lures![]() |
| ||
Posts: 786 Location: Minnesota | I mix em up. Big to small and shallow to 20 feet. I of course drag a Grunt ![]() James http://www.gruntmuskielures.com Edited by Grunt Lures 10/20/2006 9:16 PM | ||
Jump to page : 1 Now viewing page 1 [30 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |


Copyright © 2025 OutdoorsFIRST Media |