MuskieFIRST | Trailmaster bearings/hubs » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Trailmaster bearings/hubs

Message Subject: Trailmaster bearings/hubs

Bruce

Posted 4/23/2006 8:52 AM (#188492)
Subject: Trailmaster bearings/hubs

Hi. Bought this trailer two months ago. It sat on the dealers lot for 5 years, never sold. i wanted to check out the bearings and grease level before a longer trip, but the caps? are different than others i have seen. They're recessed abit, and have a bolt? in the center. It has a rounded head but has no slot like a screw would have. Does anyone have one of these trailers that can help me out here? Owners manual did not share any info. Thanks.

luredaddy

Posted 4/23/2006 1:56 PM (#188511 - in reply to #188492)
Subject: RE: Trailmaster bearings/hubs

Posts: 135

Not sure if your setup is the same as mine, but that rounded head you refer to, maybe a zerk or grease fitting. Trailmaster has a Safe T Lube system, at least mine does. If yours is the same, you remove the outside rubber seal or cover, then bend the tang washer to the free position. Then unscrew the spindle nut and remove the hub.

John

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread