MuskieFIRST | Panoptix set up » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> Panoptix set up

Message Subject: Panoptix set up

ponylou

Posted 7/5/2019 6:16 PM (#941827)
Subject: Panoptix set up

Posts: 49

Question for you all,, I just set up a Panoptix unit and mounted off the same transducer board as my solix. Both are on the Right side of the motor, opposite of the side where my units are mounted. Thinking I should have switched them both to the left so they're directly underneath? Or am I over thinking it?

Pointerpride102

Posted 7/5/2019 8:42 PM (#941830 - in reply to #941827)
Subject: Re: Panoptix set up

Posts: 16632

Location: The desert

Check out the Harmon Panoptix group on Facebook, some very informed folks on there that will likely give you the best advice on your set up, possibly faster than you’ll get it here.

25homes

Posted 7/10/2019 12:06 PM (#942057 - in reply to #941827)
Subject: Re: Panoptix set up

Posts: 983

Everyone I know running panoptix is mounting them up front on the trolling motor faced toward rear of boat haven't seen anyone mount in back of boat

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread