MuskieFIRST | 20" shaft of 25" transom » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> 20" shaft of 25" transom

Message Subject: 20" shaft of 25" transom

Bigstick56

Posted 7/24/2017 10:58 AM (#871303)
Subject: 20" shaft of 25" transom

Posts: 18

Is it possible to put a 20" motor ( Yamaha 200 SHO 20" Shaft) on a boat with a 25" Transom using a 6"+ Hydraulic Jack Plate? If it was set up so the motor is at the right height on the jack plates lowest setting, is there any reason it wouldn't work? Just thinking of possibilities, Thanks.

kjgmh

Posted 7/24/2017 12:59 PM (#871319 - in reply to #871303)
Subject: Re: 20" shaft of 25" transom

Posts: 1091

Location: Hayward, WI

It may put the motor too deep in the water. Then you can then run into issues with the exhaust under water at idle.

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread