MuskieFIRST | 2003 Honda Corrrosion » Muskie Boats and Motors

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Muskie Boats and Motors -> 2003 Honda Corrrosion

Message Subject: 2003 Honda Corrrosion

Posted 10/8/2003 6:35 AM (#84200)
Subject: 2003 Honda Corrrosion

I have a pair of 2003 Honda 130hp on a boat that I keep on Lake Erie, the boat was in the water from May until the last of Sept. When I washed the slime off the outboards both lower units are showing a lot of corrosion on the lower units directly in front of the propellors, Honda may be sending a tech down to look at them. Has anyone else seen anything like this on Hondas.

Tyler Campbell

Posted 10/12/2003 11:43 PM (#84574 - in reply to #84200)
Subject: RE: 2003 Honda Corrrosion

Posts: 172

Location: Chagrin Falls, Ohio

I don't know enough about this subject, but have read a bit about it recently, so here's my guess, and it might be a stupid one, but here it is.

I think you're grounds might not be all that great, and the sacrificial anodes might not be doing their job due to rather high voltage in the water around the boat.

Is it glass or aluminum? I'm assuming glass with two 130's.

Good fishin',

Tyler

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread