|
|
Posts: 52
| I have a Ranger 621 which has a Terrova bolted directly to the bow. I am planning to replace the Terrova with an Ulterra and would like to use a quick release bracket. Which bracket will work best? |
|
| |
|
Posts: 216
Location: Elk River, MN | MK32 - see attached pic.
I bought one when I bought my Ulterra, but chose to install the TM without it so I have this new still in the box if interested.
Let me know
Attachments
----------------
 mk32pic.jpg (117KB - 416 downloads)
|
|
| |
|
Posts: 410
Location: one foot over the line | I have used and really like the rectangular composite models. Such as model #MKA-21. When your motor is off, there is just a small, no sharp edge, solid piece left on your boat. And, it is easily lockable with a padlock. |
|
| |
|
Posts: 138
| I use the MKA-47. It's nice that it slides back 6" for storage and boat cover fit. |
|
| |
|
Posts: 216
Location: Elk River, MN | I will have to look at the 47 then as with the Ulterra mounted directly to the boat, it sits further out than my Fortrex and now my cover "is to short".
|
|
| |
|
Posts: 1209
| I use a 47 for a fortrex and a terrova, the 6" slide allows for my factory fit cover to work with my terrova otherwise it would stick out too far. And if you ever use a crazy steap ramp the 6" slide will clear the top roller on your trailer. |
|
| |
|
Posts: 100
| I've used the MKA-16-02 for years on a Terrova; just switched it out to an Ulterra. Works fine.
If I were starting from scratch, I'd go with either the MKA-21 or the MKA-47. I think they provide a more finished looking solution. |
|
| |
