MuskieFIRST | looking for 2 piece rod » Lures,Tackle, and Equipment

Muskie Discussion Forums

You are logged in as a guest. ( logon | register )

Moderators: Slamr	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [30 messages per page] Muskie Fishing -> Lures,Tackle, and Equipment -> looking for 2 piece rod

Message Subject: looking for 2 piece rod

monsterlures

Posted 9/28/2015 12:12 PM (#786335)
Subject: looking for 2 piece rod

Posts: 256

Hello everyone,

I am looking for a 2 piece rod that can throw the 16 inch 24 ounce line thru trout, anyone have any suggestions?

cave run legend

Posted 9/28/2015 12:37 PM (#786342 - in reply to #786335)
Subject: Re: looking for 2 piece rod

Posts: 2097

Look at tackle industries.

Zinox

Posted 9/28/2015 12:44 PM (#786344 - in reply to #786335)
Subject: Re: looking for 2 piece rod

Posts: 1100

The only option is the TI 2 piece, and it is possible to throw the 2 pounder with it, but it loads up really deep, but with slow casts, letting the rod work, it can do the job, relatively ok.

sworrall

Posted 9/29/2015 6:41 AM (#786472 - in reply to #786344)
Subject: Re: looking for 2 piece rod

Posts: 32886

Location: Rhinelander, Wisconsin

Abu Beast, too.

Zinox

Posted 9/29/2015 10:31 AM (#786498 - in reply to #786335)
Subject: Re: looking for 2 piece rod

Posts: 1100

Yearh the new beast rod as well, just remember, that i does not split in the middle, and its not available here in Europe.

Tackle Industries

Posted 9/29/2015 11:58 AM (#786505 - in reply to #786335)
Subject: Re: looking for 2 piece rod

Posts: 4053

Location: Land of the Musky

Franglais Fishing in Europe has the Tackle Industries 2pc rod. Its a true 2pc rod and the spigot joint is almost right in the middle of the rod. Makes it very easy for transportation of the rod even as a carry on with major airlines... Here you go:

http://www.franglaisfishing.com/ffstore/search.php?pg=1&stext=&spri...

James

Jump to page : 1
Now viewing page 1 [30 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread