Posts: 32800
Location: Rhinelander, Wisconsin | The only way there are bolts is if there's an access hole under the seat, and in that case you probably have T-nuts in there. Driver seats were installed by the dealer back then unless the factory was requested to rig the rear base. No floor base hardware went into the boat before the liner was laminated in.
There should be an aluminum plate laminated under the rear seat, and screws should be the correct fastener, but who knows what happened to the boat when it left the factory.
Attachments ---------------- everbilt-t-nuts-802301-64_1000.webp (61KB - 362 downloads)
|