Muskie Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
Posting a reply to: Re: Fuel issue on my Esox Magnum

Back
Muskie Fishing -> Muskie Boats and Motors
Guest name
Subject
Message

Emoticons
HTML: Yes
Anonymous: Yes
MBBS Code: Yes


 Disable HTML
Post anonymously
Enable emoticons



hi


You are replying to:
sworrall
Posted 5/10/2019 5:09 PM (#937196 - in reply to #937195)
Subject: Re: Fuel issue on my Esox Magnum





Posts: 32944


Location: Rhinelander, Wisconsin		The factory very probably didn't mount the seats, the dealer probably did to fit the buyer's reach unless you picked the boat up at the factory. Someone used screws that were too long.

I'd look at a 4" to 6" port. CAREFULLY cut the hole out so as not to further damage the tank. Get a flanged/gasketed screw larger than the hole caused by the screw, use a gasoline resistant sealant, and run the screw into the hole.

That thing been leaking since 2007?

(Delete all cookies set by this site)