Posts: 3480
Location: Elk River, Minnesota | btfish - 3/28/2019 7:41 AM
I am no expert but. What I was told it is not a matter if today’s outboards will run with E10 gas, they will very well.
But it’s a matter that they can cause issues stored in the boat tank because the alcohol can absorb moisture. Boats unlike cars don’t run the volume of fuel, don’t have the tanks emptied and refill at as high of frequency as a car, and most of the time sit unused for 6 months or more.
For me this post is getting long, technically complected, and confusing. Maybe I am not very smart. But I am honestly not sure now what to use?
Can anyone clarify exactly what’s the correct fuel to use?
Good Morning!!
Earlier in this thread an example was used about the water bonding with alcohol... In a 10 gallon tank, you would need to have a lot of water added to your tank of fuel (about a half cup of water) before any sort of issues would come up with separation of fluids. THAT is a bunch of water in your tank and for that amount to get in, it would somehow have to be externally introduced like leaving a gas cap off while on the water or during a huge rain storm. On some of our boats these days with 50 gallon tanks...that equates to around 2-1/2 cups of water in your tank... over a PINT!! That is just not going to happen without external introduction...
The fact that the alcohol bonds with any water intrusion is a GOOD THING!! that bond will allow the water to go right through the combustion chamber and right out your exhaust with no issues.
So...storage of ethanol fuel is actually THE BETTER option because of this bonding that takes place. There will NEVER be a condition that would allow that much water to be introduced to your fuel tank while stored... The internal portion of the tank is not exposed to air (dew in the mornings for example), and condensation would be so minimal, the alcohol in the tank bonds with it...keeping it from settling out and the fuel from separating.
Non-oxygenated fuel CANNOT bond with water...thus the water settles to the bottom of your tank, goes right in your fuel inlet to the motor..THAT is when you have problems...and that is with ANY amount of water...
Regardless of what fuel you choose to run, any storage situation should ALWAYS involve using a stabilizer of some sort. Sea Foam is a great product for this, as is STABIL, or any other brand of fuel stabilizer. We add those things to maintain the Octane level in the fuel... And guess what their main ingredient is in the can....ALCOHOL!!
E10 is a superior fuel for your tank and your engine.... Although non-oxy 91 octane might get you a very tiny amount of extra HP, you run a much higher risk of old fuel, and unless you are running some sort of stabilizing agent in it with said alcohol, you run a much higher risk of water issues, even though that risk is very small to begin with...
Steve
Edited by VMS 3/28/2019 8:31 AM
|
