Post a message

Muskie Discussion Forums

Search | Statistics | User Listing

You are logged in as a guest. ( logon | register )

Posting a reply to: Re: Etherneting on a Tuffy Esox Ltd.

Muskie Fishing -> Muskie Boats and Motors

You are replying to:

HunterDM

Posted 2/25/2018 6:41 AM (#893794 - in reply to #892984)
Subject: Re: Etherneting on a Tuffy Esox Ltd.

Posts: 38

Location: WI

Good Sunday morning to all. OK, tried fish taping from access in front several times not being able to get through. Took out the cover for the floor drain and found the 12 volt wire there with other electrical wire taped together. I then removed the drain cover and stuck my phone in the drain hole and snapped some pictures. The entire area by the bulk head which is approx. 20" from the drain hole has a plywood wall running the width of the floor and spray foamed on the bottom the entire width and all around the wire running so.... no access there. I then proceded to remove the 8" access hole by the live well to see possible options running it underneath the live well to the front since there is access to the fuses etc. from that hole. Also took some pictures there and it looks like in front of the live well towards the deck it is also spray foamed about 12" past the end of the live well. Was hoping for some luck there. The other side by the rod locker is exposed to the front storage which is nice and which is why I was hoping for the same on the live well side. Any other suggestions, was hoping for a nice clean look. Thanks guys!